DC-300 Code Key Machine and Key Duplicator
The DC-300 Duplicating Code Key Machine is two machines in one. It can both originate and duplicate automotive keys with ease.
Code-cutting a key is a simple process. Insert the depth cam and space key into the machine, slide in the blank and begin cutting. This simple procedure can be done in about 30 seconds.
Duplicating a key is even easier. Clamp both keys into the vises, turn on the machine and start cutting. Copying a key on the DC-300 takes about 20 seconds.
|
A highlight of the DC-300 is its ease of use. Only a few minutes of training are required to familiarize your employees with its features and operation.
Here are just a few of the outstanding features of the DC-300:
• As new code series are introduced, all that is needed is a new space key (in most cases). Occasionally, another depth cam may be required.
• A wire deburring brush is included with the machine. A nylon brush is also available.
•
The DC-300 consistently holds .0005" accuracy - no need to continually readjust the machine!
• The DC-300 has a double-sided vise. It will hold almost all automotive keys without any tipping. A pair of brass shims is also included with the machine in the rare case that a key tips.
When used properly, the DC9040 cutter supplied with the key machine will cut thousands of keys without the need for resharpening. Please note that the DC-300 is not designed to cut steel keys. Doing so will reduce cutter life significantly.
Sealed ball bearings are used throughout the machine. These bearings require no maintenance whatsoever. The only maintenance the DC-300 requires is regular cleaning and a few drops of oil applied as needed to the slide rod and guide.
|
